Released Firmware

[中文]

It is recommended to use the lastest version of firmware. Currently, Espressif only releases AT firmware for the following ESP32-C3 series of modules.

Note

• The current ESP32-C3 AT firmware supports ECO0 (Rev v0.0) to ECO4 (Rev v0.4) chip versions (including ECO0 and ECO4), but does not support ESP32-C3 ECO6 (Rev v1.0), ECO7 (Rev v1.1), and subsequent versions.

• If there is no released firmware for your module, you can either use the firmware for the module that has the same hardware configuration as yours (see ESP-AT Firmware Differences for which module has the same configuration), or if you need to modify the following configurations, you can generate a new firmware for your module by modifying the released firmware using the at.py Tool.

  • Modify UART Configuration

  • Modify Wi-Fi Configuration

  • Modify Certificate and Key Configuration

  • Modify GATTS Configuration

Disclaimer

Before using the AT firmware below, please read the Disclaimer carefully and comply with its terms and precautions.

ESP32-C3-MINI-1 Series

• v3.2.0.0 ESP32-C3-MINI-1-AT-V3.2.0.0.zip (Recommended)

• v2.4.2.0 ESP32-C3-MINI-1-AT-V2.4.2.0.zip

• v2.4.1.0 ESP32-C3-MINI-1-AT-V2.4.1.0.zip

• v2.4.0.0 ESP32-C3-MINI-1-AT-V2.4.0.0.zip

• v2.3.0.0 ESP32-C3-MINI-1-AT-V2.3.0.0.zip

• v2.2.0.0 ESP32-C3-MINI-1-AT-V2.2.0.0.zip

Provide feedback about this document