Migrate Tools to ESP-IDF 5.0
IDF Monitor
IDF Monitor follows the custom console baud-rate (CONFIG_ESP_CONSOLE_UART_BAUDRATE) by default instead of 115200. Setting a custom baud rate is not supported from menuconfig anymore. A custom baud-rate can be specified from command line with the idf.py monitor -b <baud> command or through setting environment variables. Please note that the baud-rate argument has been renamed from -B to -b in order to be consistent with the global baud-rate idf.py -b <baud>. Run idf.py monitor --help for more information.
Deprecated commands
idf.py sub-commands and cmake targets are unified to contain - instead of _. The following changes have been made. Deprecated sub-commands and targets produce a warning. It is advised to migrate to the new ones.
Old name |
New name |
|---|---|
efuse_common_table |
efuse-common-table |
efuse_custom_table |
efuse-custom-table |
erase_flash |
erase-flash |
partition_table |
partition-table |
partition_table-flash |
partition-table-flash |
post_debug |
post-debug |
show_efuse_table |
show-efuse-table |
erase_otadata |
erase-otadata |
read_otadata |
read-otadata |