Building OpenOCD from Sources for Windows

The following instructions are alternative to downloading binary OpenOCD from Espressif website. To quickly setup the binary OpenOCD, instead of compiling it yourself, backup and proceed to section Set up OpenOCD for Windows.

Download Sources of OpenOCD

The sources for the ESP32-enabled variant of OpenOCD are available from Espressif GitHub under To download the sources, use the following commands:

cd ~/esp
git clone --recursive

The clone of sources should be now saved in ~/esp/openocd-esp32 directory.

Install Dependencies

Install packages that are required to compile OpenOCD:


Install the following packages one by one, check if installation was successful and then proceed to the next package. Resolve reported problems before moving to the next step.

pacman -S libtool
pacman -S autoconf
pacman -S automake
pacman -S texinfo
pacman -S mingw-w64-i686-libusb-compat-git
pacman -S pkg-config


Installation of pkg-config is breaking operation of esp-idf toolchain. After building of OpenOCD it should be uninstalled. It be covered at the end of this instruction. To build OpenOCD again, you will need to run pacman -S pkg-config once more. This issue does not concern other packages installed in this step (before pkg-config).

Build OpenOCD

Proceed with configuring and building OpenOCD:

cd ~/esp/openocd-esp32

Optionally you can add make install step at the end. Skip it, if you have an existing OpenOCD (from e.g. another development platform), as it may get overwritten.


  • Should an error occur, resolve it and try again until the command make works.
  • If there is a submodule problem from OpenOCD, please cd to the openocd-esp32 directory and input git submodule update --init.
  • If the ./configure is successfully run, information of enabled JTAG will be printed under OpenOCD configuration summary.
  • If the information of your device is not shown in the log, use ./configure to enable it as described in ../openocd-esp32/doc/INSTALL.txt.
  • For details concerning compiling OpenOCD, please refer to openocd-esp32/README.Windows.

Once make process is successfully completed, the executable of OpenOCD will be saved in ~/esp/openocd-esp32/src/openocd directory.

Remove pkg-config, as discussed during installation of dependencies:

pacman -Rs pkg-config

Next Steps

To carry on with debugging environment setup, proceed to section Configuring ESP32 Target.