Setup Linux Toolchain from Scratch

Note

Standard process for installing the toolchain is described here. See Customized Setup of Toolchain section for some of the reasons why installing the toolchain from scratch may be necessary.

Install Prerequisites

To compile with ESP-IDF you need to get the following packages:

  • Ubuntu and Debian:

    sudo apt-get install gcc git wget make libncurses-dev flex bison gperf python python-pip python-setuptools python-serial python-cryptography python-future python-pyparsing
    
  • Arch:

    sudo pacman -S --needed gcc git make ncurses flex bison gperf python2-pyserial python2-cryptography python2-future python2-pyparsing
    

Note

Some older (pre-2014) Linux distributions may use pyserial version 2.x which is not supported by ESP-IDF. In this case please install a supported version via pip as it is described in section Install the Required Python Packages.

Compile the Toolchain from Source

  • Install dependencies:

    • CentOS 7:

      sudo yum install gawk gperf grep gettext ncurses-devel python python-devel automake bison flex texinfo help2man libtool
      
    • Ubuntu pre-16.04:

      sudo apt-get install gawk gperf grep gettext libncurses-dev python python-dev automake bison flex texinfo help2man libtool
      
    • Ubuntu 16.04 or newer:

      sudo apt-get install gawk gperf grep gettext python python-dev automake bison flex texinfo help2man libtool libtool-bin
      
    • Debian 9:

      sudo apt-get install gawk gperf grep gettext libncurses-dev python python-dev automake bison flex texinfo help2man libtool libtool-bin
      
    • Arch:

      TODO
      

Create the working directory and go into it:

mkdir -p ~/esp
cd ~/esp

Download crosstool-NG and build it:

git clone -b xtensa-1.22.x https://github.com/espressif/crosstool-NG.git
cd crosstool-NG
./bootstrap && ./configure --enable-local && make install

Build the toolchain:

./ct-ng xtensa-esp32-elf
./ct-ng build
chmod -R u+w builds/xtensa-esp32-elf

Toolchain will be built in ~/esp/crosstool-NG/builds/xtensa-esp32-elf. Follow instructions for standard setup to add the toolchain to your PATH.

Next Steps

To carry on with development environment setup, proceed to section Get ESP-IDF.