USB Serial/JTAG Controller Console¶
On chips with an integrated USB Serial/JTAG Controller, it is possible to use the part of this controller that implements a serial port (CDC) to implement the serial console, instead of using UART with an external USB-UART bridge chip. ESP32-C3 contains this controller, providing the following functions:
Bidirectional serial console, which can be used with IDF Monitor or another serial monitor
Flashing using
esptool.pyandidf.py flash.JTAG debugging using e.g. OpenOCD, simultaneous with serial operations
Note that, in contrast with the USB OTG peripheral found in some Espressif chips, the USB Serial/JTAG Controller is a fixed function device, implemented entirely in hardware. This means it cannot be reconfigured to perform any function other than to provide a serial channel and JTAG debugging functionality.
Hardware Requirements¶
Connect ESP32-C3 to the USB port as follows:
GPIO |
USB |
|---|---|
19 |
D+ (green) |
18 |
D- (white) |
GND |
GND (black) |
+5V (red) |
Some development boards may offer a USB connector for the USB Serial/JTAG Controller — in that case, no extra connections are required.
Software Configuration¶
USB console feature can be enabled using CONFIG_ESP_CONSOLE_USB_SERIAL_JTAG option in menuconfig tool (see CONFIG_ESP_CONSOLE_UART).
Once the option is enabled, build the project as usual.
Uploading the Application¶
The USB Serial/JTAG Controller is able to put the ESP32-C3 into download mode automatically. Simply flash as usual, but specify the USB Serial/JTAG Controller port on your system: idf.py flash -p PORT where PORT is the name of the proper port.
Limitations¶
There are several limitations to the USB console feature. These may or may not be significant, depending on the type of application being developed, and the development workflow.
If the application accidentally reconfigures the USB peripheral pins, or disables the USB Serial/JTAG Controller, the device will disappear from the system. After fixing the issue in the application, you will need to manually put the ESP32-C3 into download mode by pulling low GPIO0 and resetting the chip.
If the application enters light sleep (including automatic light sleep) or deep sleep mode, USB CDC device will disappear from the system.
The behaviour between an actual USB-to-serial bridge chip and the USB Serial/JTAG Controller is slightly different if the ESP-IDF application does not listen for incoming bytes. An USB-to-serial bridge chip will just send the bytes to a (not listening) chip, while the USB Serial/JTAG Controller will block until the application reads the bytes. This can lead to a non-responsive looking terminal program.