Configure Other JTAG Interface

[中文]

Refer to section Selecting JTAG Adapter for guidance what JTAG interface to select, so it is able to operate with OpenOCD and ESP32-C3. Then follow three configuration steps below to get it working.

Configure Hardware

  1. Identify all pins / signals on JTAG interface and ESP32-C3 board, that should be connected to establish communication.

    ESP32-C3 pins and JTAG signals

    ESP32-C3 Pin

    JTAG Signal

    MTDO / GPIO7

    TDO

    MTDI / GPIO5

    TDI

    MTCK / GPIO6

    TCK

    MTMS / GPIO4

    TMS

  2. Verify if ESP32-C3 pins used for JTAG communication are not connected to some other h/w that may disturb JTAG operation.

  3. Connect identified pin / signals of ESP32-C3 and JTAG interface.

Configure Drivers

You may need to install driver s/w to make JTAG work with computer. Refer to documentation of JTAG adapter, that should provide related details.

Connect

Connect JTAG interface to the computer. Power on ESP32-C3 and JTAG interface boards. Check if JTAG interface is visible by computer.

To carry on with debugging environment setup, proceed to section Run OpenOCD.

Provide feedback about this document