FileSystem AT Commands

[中文]

Introduction

Important

The default AT firmware does not support the AT commands listed on this page. If you need ESP32-C6 to support FileSystem commands, you can compile the ESP-AT project by following the steps in Compile ESP-AT Project Locally documentation. In the project configuration during the fifth step, make the following selections:

  • Enable Component config -> AT -> AT FS command support

AT+FS: Filesystem Operations

Set Command

Command:

AT+FS=<type>,<operation>,<filename>,<offset>,<length>

Response:

OK

Parameters

  • <type>: only FATFS is currently supported.

    • 0: FATFS

  • <operation>:

    • 0: delete file.

    • 1: write file.

    • 2: read file.

    • 3: query the size of the file.

    • 4: list files in a specific directory. Only root directory is currently supported.

  • <offset>: apply to writing and reading operations only.

  • <length>: data length, applying to writing and reading operations only.

Notes

  • This command will automatically mount the filesystem. After the AT+FS filesystem operation is all done, it is strongly recommended to use the AT+FSMOUNT=0 command to unmount the filesystem to free a large amount of RAM space.

  • Please make sure that you have downloaded at_customize.bin before using this command. For more details, refer to ESP-IDF Partition Tables and How to Customize Partitions.

  • If the length of the read data is greater than the actual file length, only the actual data length of the file will be returned.

  • If the operator is write, wrap return > after the write command, then you can send the data that you want to write. The length should be parameter <length>.

Example

// delete a file.
AT+FS=0,0,"filename"

// write 10 bytes to offset 100 of a file.
AT+FS=0,1,"filename",100,10

// read 100 bytes from offset 0 of a file.
AT+FS=0,2,"filename",0,100

// list all files in the root directory.
AT+FS=0,4,"."

AT+FSMOUNT: Mount/Unmount Filesystem

Set Command

Command:

AT+FSMOUNT=<mount>

Response:

OK

Parameters

  • <mount>:

    • 0: Unmount filesystem

    • 1: Mount filesystem

Notes

  • After the AT+FS filesystem operation is all done, it is strongly recommended to use the AT+FSMOUNT=0 command to unmount the filesystem to free a large amount of RAM space.

Example

// unmount the filesystem manually
AT+FSMOUNT=0

// mount the filesystem manually
AT+FSMOUNT=1

Provide feedback about this document